Guide column within the oil window of Shandong plastering machine, wipe board turn-up rod moving parts, the electromagnetic clutch plate clutch, hydraulic sleeve, chain, wire rope and wire to be played hard all day over oil. Caution: 1, due to the machine in wet under long-term work, so must be equipped with leakage protection. (Such as electric shock event the Company shall not be responsible for) 2, the machine is running, forbidden to stand under the machine, hand, room to move to avoid accidents. (Such as accidents, the Company shall not be responsible for) 3, when the machine is fixed after 1, first wipe off board flip lever to wipe board flip angle as plastering, point operation switch will start, which is a protective hand wall machine, to prevent scratching wipe board 2, wiping plate if not snapping the belt will not send ash. 3 machine does not stop or top down automatically, it is necessary to manually stop inverted switch, so the operator can not be away from the inverted switch. 4, the use of which inverted switch just energized without commutation, such as: increased Kai-shun, the machine will automatically stop the top, to inverted switch pull to a stop position, and then pull down to shun, non-inverted plate plastering machine structure , otherwise it will force rise, pull the bad machine. 4, regular checks of the ministries of the screws are loose. Of particular note is: pole change long or short change site plastering machine, every dish on the wire rope hoist tight, which would be in an energized state, two wire rope lifting his hands, how much rope submitted to, not to mention After them off the rope, to be able to plug in the pole so far (in other short game can be directly plugged) Plug the main bar, step hydraulic fixed, the inverted-switch commutation, lifting his hands tight rope, so that the machine can be observed on both sides up to The wire rope hoist is a groove (manual stop, inverted switch) If the tank to re-coil. Make sure the cable is not a tank, before normal use. Xingtai City Run Min Machinery Manufacturing Co., Ltd. After years of development and improvement, to produce the latest generation plastering machine, you can wipe the rim, wiping the top (1mm not leave), you can wipe the door, simple windows, columns and Yang angle, operation, efficiency High, low cost, is the preferred alternative to the traditional manual hand wall of the device. Scope: This machine is residential buildings, office buildings, houses indoor surface hardening plaster walls stand the ideal equipment. There may be impeccably Wall: cement wall, brick wall, hollow wall, lightweight brick, unburned brick wall and so on. Suitable ash are: gray white sand, stone, cement powder, foam mortar, dry mortar, plaster and so on. Plaster thickness 3cm or less, hand wall height of 5m can be used. Plastering machine direct, people-run machinery (online consultation), wall plasterer by Xingtai City public Machinery Manufacturing Co. Run. Xingtai City Run China Machinery Manufacturing Co., Ltd. (www.hbrunmin.com) Hebei Xingtai, finishing equipment leader, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Run machine in China leadership with the staff warmly welcome all inquiries negotiations to create a people-run machine a better future.